This article is more than 1 year old

Your software doesn't work when my PC is in 'O' mode

Code so clever it is like perpetual motion. In C++

On Call Modes of operation always present a challenge for users. Especially when they invent their own. Welcome to a mysterious On Call with an all-too-obvious solution.

Today's contribution comes from a reader Regomized as "Ivor" and concerns a particularly puzzling support call from a customer struggling with Ivor's software.

It was regarding a PC setting he'd never heard of. We should explain that Ivor worked as a developer and development manager for his employer for well over a quarter of century and would be forgiven for thinking he'd heard it all. But there's always that one ever so special case.

"Your software doesn't work," was the complaint. Simple enough, right?

Maybe not. Ivor explained that the customer "reported our software would only work if the computer was in 'I' mode."

"It wouldn't work in 'O' mode."

Ivor was baffled. "This was the '90s," he said, "and no one could think of such a config option in our software."

There were different modes in the platforms of the era. Who can forget Windows 3.1's "constant crashing mode" (aka "standard mode") versus the "crashes a bit less mode" (aka "enhanced mode") or the MS-DOS MODE command, responsible for setting the mode of operation for printers or the serial interface?

But "I" mode and "O" mode were new to Ivor and the team and they gently probed the increasingly frustrated customer to work out what the problem was.

The customer explained again: "Your. Software. Does. Not. Work. In. O. Mode."

Perhaps this was a reference to the MODE command of the BBC Micro Model B. MODE 0 would put Acorn's finest into 80 column mode while MODE 1 was a bit more graphical. The BBC Micro (along with its successor, the Archimedes) was, after all, only discontinued in the 1990s. So not too far-fetched… if it wasn't for the fact that this software was designed to run on a PC.

The questioning went on and when "we managed to ascertain it was a button with 'I' and 'O' on it," the penny dropped.

The customer was referring to a rocker switch on the PC. "To be precise," said Ivor, "the on/off rocker switch."

There's no record of how the conversation with the customer went as Ivor explained that "O" meant the PC was off and just about nothing would be running, not even his software. We imagine that the sentence "'O' is for Off and 'I' is for Idiot" wasn't too far from his mind.

Still, at least it gave Ivor a fresh twist on an old IT truism: "We still don't talk about 'turning it off and on'," he said, "but rather 'putting [it] into 'O' mode and then 'I' mode'."

Ever had a user who such a high opinion of your software that their expectation was that it would run even in the absence of power? How did you reset their hopes and dreams? Share your tale of support shenanigans with an email to On Call. ®

More about

More about

More about

TIP US OFF

Send us news


Other stories you might like